Surface Mounted Toilet Seat Cover Dispenser shall be 304 stainless steel alloy 18-8, and front surfaces’ cover shall be satin #4 finish. Cover dispensing slot shall have a fully deburred flat edge for snag-free dispensing and user safety. Unit shall hold and dispense 250 standard single or half-fold paper toilet seat covers or in one box. Overall Dimensions: 15 5/8” W x 11 7/16” H x 17/8” D (397mm x 290.3mm x 48mm).
Surface Mounted Toilet Seat Cover Dispenser shall be Model #TSC-100 of Metpar Corporation, 95 State Street, Westbury, NY 11590.
Dispenses single or half-fold paper toilet seat covers from concealed beveled opening until supply is depleted. Unit is manually reloaded with a full box from bottom through concealed opening on schedule determined by maintenance requirements. Capacity is 250 toilet seat covers.
Unit to be surface mounted at desired or specified location on wall or partition using two (2) No. 8 self-tapping pan head screws through concealed holes (only visible when tissue box removed). Mounting holes are provided in back plate of dispenser and are accessible through door for installation. Provide a 5’’ (125mm) minimum clearance from bottom of dispenser to top of any horizontal projection to provide room for filling dispenser from bottom. For compliance with ADA Accessibility Guidelines, install unit so that centerline of dispenser slot is a maximum of 48” (1219mm) above finished floor if clear floor access if provided or a maximum of 46” (1168mm) above finished floor if side reach over an obstruction only is provided.